[1]孙志翱,金保升,章名耀,等.流化床燃烧棉秆与床料的混合特性及混合质量评判标准[J].东南大学学报(自然科学版),2007,37(6):996-1000.[doi:10.3969/j.issn.1001-0505.2007.06.011]
 Sun Zhiao,Jin Baosheng,Zhang Mingyao,et al.Experimental studies on mixing characteristics and criterion of cotton stalk combustion in fluidized bed[J].Journal of Southeast University (Natural Science Edition),2007,37(6):996-1000.[doi:10.3969/j.issn.1001-0505.2007.06.011]
点击复制

流化床燃烧棉秆与床料的混合特性及混合质量评判标准()
分享到:

《东南大学学报(自然科学版)》[ISSN:1001-0505/CN:32-1178/N]

卷:
37
期数:
2007年第6期
页码:
996-1000
栏目:
能源与动力工程
出版日期:
2007-11-20

文章信息/Info

Title:
Experimental studies on mixing characteristics and criterion of cotton stalk combustion in fluidized bed
作者:
孙志翱 金保升 章名耀 刘仁平 张华钢
东南大学能源与环境学院, 南京 210096
Author(s):
Sun Zhiao Jin Baosheng Zhang Mingyao Liu Renping Zhang Huagang
School of Energy and Environment, Southeast University, Nanjing 210096, China
关键词:
棉秆 流化床燃烧 床料 混合 标准
Keywords:
cotton stalk fluidized bed combustion bed material mixing criterion
分类号:
TK6
DOI:
10.3969/j.issn.1001-0505.2007.06.011
摘要:
论述了10~100 mm长度的棉秆与弱酸性床料的混合流化特性,研究了棉秆长度、床料粒径、配比和流化风速等因素对混合均匀程度的影响.试验结果表明:长度100 mm以下特别是50 mm左右的棉秆,与粒径为0.6~1 mm的床料,在配比为2%(初始质量分数),流化数大于3时,能较均匀地混合流化; 但流化数大于7时,混合均匀程度有所降低.棉秆与床料的不同配比对混合均匀程度也有影响,棉秆的质量配比越小,混合得越均匀,所以设计流化床锅炉时流化风速、静止床高要选择合理,否则会影响到密相区的稳定燃烧.提出了秸秆流化床燃烧时,秸秆与床料混合质量的评判标准,并介绍了混合均匀度的概念.在一定的试验条件下,当混合均匀度小于1.4时,秸秆和床料混合比较均匀,能够适合流化床燃烧.
Abstract:
The mixing characteristics of binary mixture of cotton stalk with 10-100 mm length and alternative bed material in a fluidized bed were studied. Experiments on a cold test facility show that long cotton stalk cannot fluidize, and adding bed material can improve the fluidization condition. Effects of length and mass percentage of cotton stalk, diameter of bed material and gas velocity on cotton stalk mixing were investigated. Long cotton stalk can mix well with 0.6-1 mm alternative bed material as fluidization number ranging between 3-7. The minimum fluidizing velocity of the binary mixture of long cotton stalk and 0.6-1 mm bed material can be obtained by experiments. In addition, the mixing criterion for binary mixture of long cotton stalk and bed material in experimental conditions is presented. When the degree of mixing is less than 1.4, the mixing state of long cotton stalk and bed material can mix well and adapt to fluidized bed combustion.

参考文献/References:

[1] Skrifvars B J,Backman R,Hupa M,et al.Ash behaviour in a CFB boiler during combustion of coal,peat or wood [J].Fuel,1998,77(2):65-70.
[2] Tillman D A.Biomass cofiring:the technology,the experience,the combustion consequences [J].Biomass and Bioenergy,2000,19(6):365-384.
[3] Galgano A,Salatino P,Crescitelli S,et al.A model of the dynamics of a fluidized bed combustor burning biomass [J]. Combustion and Flame,2005,140(4):371-384.
[4] Kristensen E F,Kristensen J K.Development and test of small-scale batch-fired straw boilers in Denmark [J]. Biomass and Bioenergy,2004,26(6):561-569.
[5] Abdullah M Z,Husain Z,Yin S L.Analysis of cold flow fluidization test results for various biomass fuels [J].Biomass and Bioenergy,2003,24(6):487-494.
[6] Huilin L,Yurong H,Gidaspow D,et al.Size segregation of binary mixture of solids in bubbling fluidized beds [J].Powder Technology,2003,134(2):86-97.
[7] Coltters R,Rivas A L.Minimum fluidation velocity correlations in particulate systems [J]. Powder Technology,2004,147(3):34-48.
[8] Sjosten J,Golriz M R,Grace J R.Further study on the influence of particle coating on fluidized bed heat transfer [J].International Journal of Heat and Mass Transfer,2006,49(22):3800-3806.
[9] Fernandez M J,Escalada R,Murillo J M,et al.Combustion in bubbling fluidized bed with bed material of limestone to reduce the biomass ash agglomeration and sintering [J]. Fuel,2006,85(15):2081-2092.
[10] Shimizu T,Han J,Choi S,et al.Fluidized-bed combustion characteristics of cedar pellets by using an alternative bed material [J].Energy & Fuels,2006,20(6):2737-2742.
[11] Kozanoglu B U,Welti J,Garcia D,et al.Hydrodynamics of large particle fluidization in reduced pressure operations:an experimental study [J].Powder Technology,2002,125(1):55-60.
[12] Caicedo G R,Ruiz M G,Prieto J J,et al.Minimum fluidization velocities for gas-solid 2D beds [J]. Chemical Engineering and Processing,2002,41(9):761-764.
[13] Fang M,Yang L,Chen G,et al.Experimental study on rice husk combustion in a circulating fluidized bed [J]. Fuel Processing Technology,2004,85(11):1273-1282.
[14] Rao T R,Ram J V.Minimum fluidization velocities of mixtures of biomass and sands [J].Energy,2001,26(6):633-644.
[15] Clarke K L,Pugsley T,Hill G A.Fluidization of moist sawdust in binary particle systems in a gas-solid fluidized bed [J]. Chemical Engineering Science,2005,60(24):6909-6918.

相似文献/References:

[1]胡达,陆勇,姚伟文.常压流化床中螺纹埋管的双边传热[J].东南大学学报(自然科学版),1989,19(3):61.[doi:10.3969/j.issn.1001-0505.1989.03.009]
 Hu Da Lu Yong(Thermal Energy Engineering Research Institute)Yao Weiwen (Nanjing College of Electric Power).Heat Transfer on Two-side Helical Tube in the Ambient Fluidized Bed[J].Journal of Southeast University (Natural Science Edition),1989,19(6):61.[doi:10.3969/j.issn.1001-0505.1989.03.009]

备注/Memo

备注/Memo:
基金项目: 国家重点基础研究发展计划(973计划)资助项目(2007CB210208).
作者简介: 孙志翱(1971—),男,博士生; 金保升(联系人),男,教授,博士生导师,bsjin@seu.edu.cn.
更新日期/Last Update: 2007-11-20