[1]金磊,钱振东,郑彧.基于DMA方法的浇注式沥青胶浆高温性能及评价指标[J].东南大学学报(自然科学版),2014,44(5):1062-1067.[doi:10.3969/j.issn.1001-0505.2014.05.033]
 Jin Lei,Qian Zhendong,Zheng Yu.High temperature performance and evaluation index of gussasphalt mortar based on DMA method[J].Journal of Southeast University (Natural Science Edition),2014,44(5):1062-1067.[doi:10.3969/j.issn.1001-0505.2014.05.033]
点击复制

基于DMA方法的浇注式沥青胶浆高温性能及评价指标()
分享到:

《东南大学学报(自然科学版)》[ISSN:1001-0505/CN:32-1178/N]

卷:
44
期数:
2014年第5期
页码:
1062-1067
栏目:
交通运输工程
出版日期:
2014-09-20

文章信息/Info

Title:
High temperature performance and evaluation index of gussasphalt mortar based on DMA method
作者:
金磊钱振东郑彧
东南大学智能运输系统研究中心, 南京 210096
Author(s):
Jin Lei Qian Zhendong Zheng Yu
Intelligent Transportation System Institute, Southeast University, Nanjing 210096, China
关键词:
动态力学分析 浇注式沥青胶浆 广义剪切模量 贯入度
Keywords:
dynamic mechanical analysis gussasphalt mortar generalized shear modulus penetration
分类号:
U414
DOI:
10.3969/j.issn.1001-0505.2014.05.033
摘要:
为了研究浇注式沥青胶浆的高温性能及评价指标,采用动态力学分析(DMA)方法,通过动态剪切流变试验,探讨了不同温度、沥青种类、粉胶比对浇注式沥青胶浆高温性能的影响.分析了广义剪切模量与浇注式沥青混合料高温变形之间的相关性,探讨了该指标作为浇注式胶浆高温性能评价指标的适用性,并以车辙深度为控制标准,对广义剪切模量以及60℃条件下的贯入度提出了建议值.结果表明:浇注式沥青胶浆复数剪切模量和相位角受温度、沥青种类、粉胶比因素影响明显;广义剪切模量与混合料永久变形呈良好的线性关系,能作为一种合适的劲度指标评价浇注式沥青胶浆的高温稳定性;60 ℃条件下,浇注式沥青混合料贯入度指标建议值不大于3.29mm.
Abstract:
In order to research the high temperature performance and evaluation index of gussasphalt mortar, the effects of different temperatures, asphalt types and filler-asphalt ratios on the high temperature properties of gussasphalt mortar were investigated based on the dynamic mechanical analysis(DMA)method and dynamic shear rheological tests. The correlation between the generalized shear modulus and high temperature deformation of gussasphalt mixture was analyzed. The suitability of generalized shear modulus used as an evaluation index of the high temperature performance of gussasphalt mortar was discussed. By taking the rutting depth as the control criterion, the recommended values of generalized shear modulus and the penetration under 60℃ were provided. The results show that the complex shear modulus and phase angle of gussasphalt mortar are affected obviously by temperature, asphalt type and filler-asphalt ratio. The relationship between the mixture permanent deformation and the generalized shear modulus appears favorably linear. And the generalized shear modulus can be used as a stiffness index to evaluate the high temperature stability of gussasphalt mortar. The recommended penetration index of gussasphalt mixture under 60℃ is no more than 3.29mm.

参考文献/References:

[1] 郭利平,张争奇,张伟,等.基于高温和粘结性能的橡胶沥青胶浆性能研究[J].武汉理工大学学报,2012,34(1):46-51.
  Guo Liping, Zhang Zhenqi, Zhang Wei, et al. Study on the mucilage performance of rubber asphalt based on high temperature properties and bond behavior[J].Journal of Wuhan University of Technology, 2012, 34(1):46-51.(in Chinese)
[2] 柳浩,李晓明,张肖宁,等,消石灰与矿粉沥青胶浆流变性能比较[J].北京工业大学学报,2009,35(11):1506-1511.
  Liu Hao, Li Xiaomin, Zhang Xiaoning, et al. Compared rheology of asphalt mastics performance with hydrated lime and limestone filer[J].Journal of Beijing University of Technology, 2009, 35(11):1506-1511.(in Chinese)
[3] 李宏志,郑健龙.温拌沥青胶浆流变性能研究[J]. 长安大学学报,2013,33(6):22-27.
  Li Hongzhi, Zhang Jianlong. Research on rheological properties of warm mix asphalt mortar[J].Journal of Chang’an University, 2013, 33(6):22-27.(in Chinese)
[4] 张华,钱觉时,吴文军.粉胶比对浇注式沥青胶浆高低温性能的影响[J].重庆大学学报,2009, 32(6):663-667.
  Zhang Hua, Qian Jueshi, Wu Wenjun. The influence of the filler-asphalt ratio on the high-and-low temperature performance of gussasphalt mortar[J].Journal of Chongqing University, 2009, 32(6):663-667.(in Chinese)
[5] Chen J S, Lin K Y. Mechanism and behavior of bitumen strength reinforcement using fibers[J].Journal of Materials Science, 2005, 40(1):87-95.
[6] 邹桂莲, 袁燕, 张肖宁.填料对沥青胶浆路用性能的影响[J].华南理工大学学报:自然科学版, 2005, 33(1):52-56.
  Zou Guilian, Yuan Yan, Zhang Xiaoning. Effect of fillers on the pavement performance of asphalt binder [J]. Journal of South China University of Technology: Natural Science Educition, 2005, 33(1):52-56.(in Chinese)
[7] Shenoy A. Prediction of high temperature rheological properties of aged asphalts from the flow data of the original unaged samples [J]. Construction and Building Materials, 2002,16(8):509-517.
[8] Dallas N L, Claine P J. Unique effects of hydrated lime filler on the performance relate properties of asphalt cement: physical and chemical interaction revisited [J].Journal of Materials in Civil Engineering, 2005, 17(2):207-218.
[9] Szydlo A, Mackiewicz P. Asphalt mixes deformation sensitivity to change in rheological parameters[J].Journal of Materials in Civil Engineering, 2005, 17(1):1-9.
[10] Shenoy A. Refinement of the superpave specification parameter for performance grading of asphalt [J]. Journal of Transportation Engineering, 2001, 127(5):357-362.
[11] 韩海峰,何桂平,吕伟民.沥青混合料永久变形特性对结合料广义动态剪切模量的响应[J].公路交通科技, 2004, 21(3):1-5.
  Han Haifeng, He Guiping, Lü Weimin. Permanent deformation response of asphalt mixture to generalized dynamic shear modulus of asphalt binder[J]. Journal of Hightway and Transportation Research and Development, 2004, 21(3):1-5.(in Chinese)
[12] 谭忆秋,李晓琳,吴建涛,等.温度及荷载频率对沥青-集料交互作用能力的影响[J].中国公路学报,2012,25(3): 65-72.
  Tan Yiqiu, Li Xiaolin, Wu Jiantao, et al. Influence of temperature and loading frequency on the interaction ability of asphalt and aggregate[J].China Journal of Highway and Transport, 2012, 25(3): 65-72.(in Chinese)
[13] 中华人民共和国交通部.JTJ 073.2—2001 公路沥青路面养护技术规范[S].北京:人民交通出版社,2001.
[14] 樊叶华.重载条件下钢桥面浇注式沥青铺装特性研究[D].南京:东南大学交通学院, 2009.

备注/Memo

备注/Memo:
收稿日期: 2014-04-10.
作者简介: 金磊(1983—),男,博士生;钱振东(联系人),女,博士,教授,博士生导师,qianzd@seu.edu.cn.
基金项目: “十一五”国家科技支撑计划资助项目(2009BAG15B03)、国家自然科学基金资助项目(51378122).
引用本文: 金磊,钱振东,郑彧.基于DMA方法的浇注式沥青胶浆高温性能及评价指标[J].东南大学学报:自然科学版,2014,44(5):1062-1067. [doi:10.3969/j.issn.1001-0505.2014.05.033]
更新日期/Last Update: 2014-09-20