[1]王晨光,张元海.基于外荷载修正的箱形梁横向内力分析[J].东南大学学报(自然科学版),2021,51(1):23-29.[doi:10.3969/j.issn.1001-0505.2021.01.004]
　Wang Chenguang,Zhang Yuanhai.Transverse internal force analysis on box girder based on external load correction[J].Journal of Southeast University (Natural Science Edition),2021,51(1):23-29.[doi:10.3969/j.issn.1001-0505.2021.01.004]
点击复制

基于外荷载修正的箱形梁横向内力分析()
分享到：

《东南大学学报(自然科学版)》[ISSN:1001-0505/CN:32-1178/N]

卷:
51
期数:
2021年第1期
页码:
23-29
栏目:
交通运输工程
出版日期:
2021-01-20

文章信息/Info

Title:
Transverse internal force analysis on box girder based on external load correction
作者:
王晨光; 张元海
兰州交通大学土木工程学院, 兰州 730070
Author(s):
Wang Chenguang;  Zhang Yuanhai
School of Civil Engineering, Lanzhou Jiaotong University, Lanzhou 730070, China
关键词:
箱形梁;  框架分析;  横向内力;  荷载修正
Keywords:
box girder;  frame analysis;  transverse internal force;  load correction
分类号:
U448.213
DOI:
10.3969/j.issn.1001-0505.2021.01.004
摘要:
为了合理计算薄壁箱梁在偏心荷载作用下的横向内力,采用弹性支承梁理论对作用在薄片框架上的外荷载进行修正.根据箱形梁畸变位移与框架位移之间的协调关系,采用满足平衡条件的新计算模型,推导出计算箱形梁横向内力的基本公式,并分析了几何参数对箱形梁横向内力的影响.结果表明,当高宽比小于1.5时,横向弯矩降低幅度较大,且在远离跨中截面处以较快的速度衰减;当高宽比大于1.5时,横向弯矩降低幅度较小,且在箱形梁跨中大部分范围内基本保持不变.与有限元计算结果相比,全梁各横截面计算误差均小于10%.基于修正的外荷载计算所得的箱形梁沿跨度方向的横向弯矩较推广的TYL框架分析法精度更高.
Abstract:
To reasonably calculate the transverse internal force of a thin-walled box girder under the eccentric load, the elastically supported girder theory was used to correct the external load acting on the frame. According to the coordination relationship between the deformation displacement of the box girder and the displacement of the frame, the basic formulas for calculating the transverse internal force of the box girder were derived by using a new calculation model satisfying the equilibrium conditions. The influence of the geometric parameters on the transverse internal force of the box girder was investigated. The results show that when the aspect ratio is less than 1.5, the transverse bending moments decrease obviously, and those away from the middle section of the span decay rapidly. However, when the aspect ratio is higher than 1.5, the decreasing degrees in the transverse bending moments are smaller, and the transverse bending moments remain basically unchanged in the most range of the span of the box girder. Compared with the results of finite element calculation, the calculation error of each cross section of the whole girder is less than 10%. The transverse bending moments calculated based on the modified external load have better accuracy than those by the generalized TYL frame method along the span direction.

参考文献/References:

[1] 赵品, 叶见曙. 波形钢腹板单箱多室箱梁横向受力分析[J]. 哈尔滨工程大学学报, 2018, 39(6): 1109-1115. DOI:10.11990/jheu.201610073.
Zhao P, Ye J S. Transverse force study of single box multi-chamber with corrugated steel webs[J]. Journal of Harbin Engineering University, 2018, 39(6): 1109-1115. DOI:10.11990/jheu.201610073. (in Chinese)
[2] 汪洋生, 张元海. 斜腹板薄壁箱梁横向内力分析及其参数影响研究 [J]. 铁道学报, 2017, 39(3):104-111. DOI:10.3969/j.issn.1001-8360.2017.03.017.
Wang Y S, Zhang Y H. Research on transverse internal force and its parameter influence of thin-walled box girders with inclined webs [J]. Journal of the China Railway Society, 2017, 39(3): 104-111. DOI:10.3969/j.issn.1001-8360.2017.03.017. (in Chinese)
[3] 项贻强, 李少骏, 刘丽思, 等. 多梁式钢-混组合小箱梁横向受力性能[J]. 中国公路学报, 2015, 28(7): 31-41,51. DOI:10.19721/j.cnki.1001-7372.2015.07.005.
Xiang Y Q, Li S J, Liu L S, et al. Lateral mechanical performance of multi-small box reinforced concrete composite girder[J]. China Journal of Highway and Transport, 2015, 28(7): 31-41,51. DOI:10.19721/j.cnki.1001-7372.2015.07.005. (in Chinese)
[4] Lin Z F, Liu Y Q, Roeder C W. Behavior of stud connections between concrete slabs and steel girders under transverse bending moment[J].Engineering Structures, 2016, 117: 130-144. DOI:10.1016/j.engstruct.2016.03.014.
[5] Rambo-Roddenberry M, Kuhn D, Glenn Tindale R Jr. Barrier effect on transverse load distribution for prestressed concrete segmental box girder bridges[J].Journal of Bridge Engineering, 2016, 21(6): 04016019. DOI:10.1061/(asce)be.1943-5592.0000814.
[6] Recupero A, Granata M F, Culotta G, et al. Interaction between longitudinal shear and transverse bending in prestressed concrete box girders[J].Journal of Bridge Engineering, 2017, 22(1): 04016107. DOI:10.1061/(asce)be.1943-5592.0000990.
[7] Stefanou G D, Dritsos S, Bakas G J. The effects of additional deformations in box-beam bridges on the longitudinal stresses and transverse moments[J].Computers & Structures, 1983, 16(5): 613-628. DOI:10.1016/0045-7949(83)90110-4.
[8] Kurian B, Menon D. Correction of errors in simplified transverse bending analysis of concrete box-girder bridges[J].Journal of Bridge Engineering, 2005, 10(6): 650-657. DOI:10.1061/(asce)1084-0702(2005)10:6(650).
[9] Kurian B, Menon D. Simplified method for transverse bending analysis of concrete box-girder bridges[J].Journal of Structural Engineering(Madras), 2006, 33(2): 121-127.
[10] 王晨光, 张元海. 几何特性对薄壁箱梁畸变效应的影响[J]. 东南大学学报(自然科学版), 2020, 50(1): 89-95. DOI:10.3969/j.issn.1001-0505.2020.01.012.
Wang C G, Zhang Y H. Influence of geometric characteristics on distortion effect of thin-walled box girders[J]. Journal of Southeast University(Science and Technology), 2020, 50(1): 89-95. DOI:10.3969/j.issn.1001-0505.2020.01.012. (in Chinese)

相似文献/References:

[1]王晨光,张元海.几何特性对薄壁箱梁畸变效应的影响[J].东南大学学报(自然科学版),2020,50(1):89.[doi:10.3969/j.issn.1001-0505.2020.01.012]
　Wang Chenguang,Zhang Yuanhai.Influence of geometric characteristics on distortion effect of thin-walled box girders[J].Journal of Southeast University (Natural Science Edition),2020,50(1):89.[doi:10.3969/j.issn.1001-0505.2020.01.012]

备注/Memo

备注/Memo:
收稿日期: 2020-05-03.
作者简介: 王晨光(1992—),男,博士生; 张元海(联系人),男,博士,教授,博士生导师,zyh17012@163.com.
基金项目: 国家自然科学基金资助项目(51468032,51968040)、兰州交通大学青年基金资助项目(2019024).
引用本文: 王晨光,张元海.基于外荷载修正的箱形梁横向内力分析[J].东南大学学报(自然科学版),2021,51(1):23-29. DOI:10.3969/j.issn.1001-0505.2021.01.004.
更新日期/Last Update: 2021-01-20